Question 1

How much does piling cost?

Accepted Answer

The cost of a piling project depends on ground conditions, pile type, diameter, depth and the number of piles required. The only way to give a meaningful figure is to assess the site. Quotes are free and provided within 48 hours of the site visit — call 07501 219642 to get the process started.

Question 2

How quickly can you start work?

Accepted Answer

Lead times vary depending on the programme and site location, but Taurus will respond to every enquiry with a quote within 48 hours of the site visit. If you have a start date in mind, mention it when you call and we will tell you whether it is achievable. Most projects run for approximately two weeks from mobilisation.

Question 3

Are you accredited for commercial projects?

Accepted Answer

Yes. Taurus holds four industry accreditations: CHAS Accredited Contractor, SSIP Registered Member, PQS Pre-Qualification Health & Safety Approved, and Constructionline Associate Member. These cover the health and safety, pre-qualification and contractor vetting requirements that commercial clients, developers and architects typically require before appointing a piling contractor.

Question 4

Is the quote really free — is there a call-out charge?

Accepted Answer

No call-out charge, no consultation fee, no obligation. You get a written quote within 48 hours of the site visit and you only proceed if you want to. The quote process costs you nothing.

Question 5

Can you work on restricted access sites — we have a very tight plot in London?

Accepted Answer

Yes. Taurus operates both restricted access rigs and open site rigs, including Grundomat equipment designed for low-headroom and narrow-access sites. Tight rear gardens, London terraces, town centre sites with no vehicle access — these are the jobs Taurus takes on specifically. If you have been told your site is not workable, call and describe the constraints before writing it off.

Question 6

What does "design and construct" mean — do I need to hire my own structural engineer?

Accepted Answer

No. Taurus provides a complete design and construct package up to DPC, which means the pile design, the installation specification and the physical construction are all handled in-house by the same team. You do not need to appoint a separate structural engineer for the piling design stage. This cuts the time between appointment and start on site, and removes the communication gap that opens up when design and build are split across two contractors.

Accreditations & Compliance

CHAS Accredited Contractor

SSIP Registered Member

PQS Pre-Qualification Health & Safety Approved

Constructionline Associate Member

Insurance & Health & Safety

Request Compliance Documentation